Guest
Show Posts
1
General Mach Discussion / Setting up limit switches, Mach3
« on: May 04, 2018, 06:40:55 AM »
Hello all,
I recently bought a chinese CNC Router, controlled by an "Nmotion Mach3 USB motion card" (which seems to be quite shady (?), see attached picture).
The manufacturer won't answer my requests for support and didn't send any documentation, so I'm a bit lost.
I'm trying to configure the limit switches (end stops), but I can't get them to work. When they are active, they are detected by Mach3 on the Diagnostics screen, but it doesn't stop the machine as it should.
How can i configure Mach3 so that is stops the machine when the limit switches are active ?
Thank you !
I recently bought a chinese CNC Router, controlled by an "Nmotion Mach3 USB motion card" (which seems to be quite shady (?), see attached picture).
The manufacturer won't answer my requests for support and didn't send any documentation, so I'm a bit lost.
I'm trying to configure the limit switches (end stops), but I can't get them to work. When they are active, they are detected by Mach3 on the Diagnostics screen, but it doesn't stop the machine as it should.
How can i configure Mach3 so that is stops the machine when the limit switches are active ?
Thank you !