Hello Guest it is August 08, 2020, 11:06:31 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - -Oscar-

Pages: 1
1
Mach3 under Vista / Re: Application Watchdog Triggered Error
« on: April 18, 2018, 10:16:50 PM »
I've emailed them and just posted to their forum. Hopefully someone will get back to me soon. Thanks.

2
Mach3 under Vista / Re: Application Watchdog Triggered Error
« on: April 18, 2018, 09:55:46 PM »
Warp9 ESS with a Gecko g540... Mach3 R3.043.062 with a legit license

3
Mach3 under Vista / Re: Application Watchdog Triggered Error
« on: April 18, 2018, 09:35:47 PM »
Even if that were the case, it would only be suppressing the issue and not resolving it. With the watchdogs off, I get an issue with the PWM signal that maxes out the router for some reason.

4
General Mach Discussion / Re: Mach3 w/smoothstepper and EStop issue...
« on: April 18, 2018, 09:33:54 PM »
I've adjusted the watchdog timer and still get the same issue. I can't find any reference anywhere to "Application Watchdog" and what it might mean. A lot pf people report Driver watchdogs but not Application.

5
Mach3 under Vista / Re: Application Watchdog Triggered Error
« on: April 18, 2018, 12:01:05 AM »
I've tried turning off the watchdog option and it doesn't seem to help. I still get the same error message on start up and random e-stops.

6
Mach3 under Vista / Re: Application Watchdog Triggered Error
« on: April 17, 2018, 03:20:16 PM »
Any luck on the 'Application Watchdog Triggered' error? I'm getting the same message and I'm having random e-stops that need the controller power cycled to reset.

7
General Mach Discussion / Re: Mach3 w/smoothstepper and EStop issue...
« on: April 17, 2018, 03:19:06 PM »
Any luck on the 'Application Watchdog Triggered' error? I'm getting the same message and I'm having random e-stops that need the controller power cycled to reset.

Pages: 1