Messages

1

General Mach Discussion / Re: Step and Dir to Analogue converter

« on: July 18, 2007, 02:42:02 PM »

Rutex has step converter but I think it's out of order now. No. rh911 .  It didn't work that i know. Only has Pixie p100 Now which work.
but It's very hard to contact him.

2

General Mach Discussion / do you know vitalsystem Dsp/mc/ip

« on: July 18, 2007, 02:07:55 PM »

I visited this web. This card can control 8 axis and there are Plc on board. It's very interest and low cost controller but Nobody ever used it.it compatable with mach3? i don't have information of them.