Hello Guest it is December 08, 2019, 02:29:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ahmadmechanic

Pages: 1
1
   Hello Everyone,
        I know this is a long shot,but is there anyone planning on attending the Mach CNC Convention coming from New Jersey that might want to consider a carpool and shared fuel expenses etc ?
  A round trip flight from NJ to Knoxville is upwards of $200 and the same upwards $ 200 could transport several people in decent vehicle to and from the convention.
  Just never mind the 24hrs. on the road with strangers  and 2 lost days in the workshop. But Hey! At least everyone would have something in common. Just some thoughts.
  Seriously though.Any takers?
  Ali Ahmad
  3D Design and Fabrication
  Fine Art Bronze Casting
   Ventnor,NJ 08406

Pages: 1