Messages

1

FAQs / Re: Help with my THC control

« on: March 31, 2018, 11:59:52 AM »

Also I use sheetcam I was wondering what post processor I should use and I do not have a floating head any ideas

2

FAQs / Re: Help with my THC control

« on: March 31, 2018, 09:35:12 AM »

Thanks now my new issue is when you're getting ready to cut the torch starts its Pierce  then just starts going up and never comes back down I have to stop the process. It works in simulation mode torch on Z up Z down and so forth.

3

FAQs / Help with my THC control

« on: March 30, 2018, 08:47:45 PM »

I got the proma THC controller to work in simulation mode but when I go to use it still runs into the metal any ideas

4

FAQs / Help with my THC control

« on: March 30, 2018, 03:55:44 PM »

I have proma THC 150 and mach3 is not recognizing my Z up. it sees Z down and THC on also torch on but not my Z up. Any ideas?