Hello Guest it is May 31, 2023, 01:08:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - lecso77

Pages: 1
PoKeys / Re: NPN proximity sensors 24v supply & pokeys 57
« on: June 14, 2022, 05:34:25 AM »
Why don't you use an optocoupler for this purpose? There is also a wiring diagram in the PoKeys manual.
You will need (per sensor) 1 optocoupler, 1 2k2 resistor, 1 390R resistor, 1 5k1 resistor. You solder it to a test panel and you're done.
Or: you buy the factory PoOptoIn panel from the manufacturer's site. (See: https://www.poscope.com/product/pooptoin/ )

PoKeys / Re: Problem with Pokeys 57U
« on: June 14, 2022, 05:22:56 AM »

How did you connect the DM542 drive to your PoKeys controller? Which pins do you use? Is the device firmware up to date? (I have seen a change from before.)

Pages: 1