1
General Mach Discussion / Re: X Y axis move togehter with Arrows key
« on: March 02, 2018, 10:16:51 AM »
Thanks everyone///Thanks for your support ...Craig , Klaus , Roger ..... problem solved by assigning corresponding Hotkeys...
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi Roger,THANKS ALOT KLAUS....PROBLEM SOLVED
I also don't have a pendant. Try the following:
Ports and Pins -> Input Signals
Jog X++ Enabled Emulated Hotkey 38 (arrow up)
Jog X-- Enabled Emulated Hotkey 40 (arrow down)
Jog Y++ Enabled Emulated Hotkey 39 (arrow right)
Jog Y-- Enabled Emulated Hotkey 37 (arrow left)
Apply
Reset
occasionally I had to change the Jog mode with the fly out dialog
Jogging with the arrow keys up, down, left or riight show x and y movement on the DRO's
Klaus
Ok Klaus,Hi Klaus I mailed you the XML files don't know whether you were asking for the same or something else..
I'll send you till tomorrow ..Today out of station.
Thanks for your support.
regards,
DD