Messages

1

PoKeys / PoKeys homing limit switch issues

« on: February 18, 2018, 05:40:15 PM »

I am about at the end of my rope on getting Mach3 to home properly with PoKeys. I just installed a PoKey 57E interface card. I have all the motions running correctly and the limit switches all working. I have the Limit + and limit - wired in series with the home limit switch being the limit- switch. The switches come in and triggers just fine.

When I try to run to REF ALL HOME in Mach3 it runs to the Z - limit switch and stops and gives me a limit switch triggered error and stops. It will not back off the limit switch.

Is there a configuration I am missing? In Mach3 or pulse engineV2?

Thanks
Schrubber