Hello Guest it is May 18, 2021, 05:40:58 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - FORBRI40

Pages: 1
1
General Mach Discussion / Re: LOST BUT NOT BEATEN
« on: February 15, 2018, 10:04:50 AM »
YES

2
General Mach Discussion / Re: LOST BUT NOT BEATEN
« on: February 15, 2018, 06:46:30 AM »
As a follow up. I reviewed the G code last night and it is correct. All of the moves in the G code goes exactly where it should. So Im unsure of what to check now. The tool path on the screen matches what is being cut and that is incorrect.

3
General Mach Discussion / Re: LOST BUT NOT BEATEN
« on: February 14, 2018, 03:33:22 PM »
ger21,

NO IT DOES NOT

4
General Mach Discussion / Re: LOST BUT NOT BEATEN
« on: February 14, 2018, 12:21:27 PM »
Tweakie, I am at work but will post the G code as soon as I get home.

5
General Mach Discussion / Re: LOST BUT NOT BEATEN
« on: February 14, 2018, 10:25:34 AM »
I have checked and triple checked all the mechanics and all is good. As I said before, Last night I ran an older program and it ran perfect but anything that I create now has problems with not completing or leaving gaps of uncut spaces.

6
General Mach Discussion / Re: LOST BUT NOT BEATEN
« on: February 14, 2018, 07:00:00 AM »
First of all thank you for the replies.
I did not mention that I did check all set screws and mounts for the motors and the ballscrew. The racks and pinions are all tight. I did take a program last night that I used to run alot and it ran perfectly. It was about a two hour program and never missed a beat. Now Im thinking it may be something in aspire but I just dont know where to look.

7
General Mach Discussion / LOST BUT NOT BEATEN
« on: February 13, 2018, 01:35:00 PM »
GOOD MORNING ALL,

I NEED HELP PLEASE,
I RECENTLY BUILT A 5' X 8' CNC WOOD ROUTER. IT IS DRIVEN BY RACK AND PINIONS ON X AND Y AXIS. THE Z IS A BALLSCREW. I AM USING CLEARPATH SERVO MOTORS ON ALL AXIS'S. SINCE WE BUILT THE MACHINE IT HAS RUN BEAUTIFULLY. JUST ABOUT A WEEK AGO WE WERE TRYING TO CUT SOMETHING AND THE MACHINE WOULD MISS CUTTING SECTIONS OF THE PROGRAM. IT HAS BEEN GETTING WORSE AND WORSE. A FEW NIGHTS AGO I DREW FIVE RECTANGLES IN VETRIC ASPIRE. I PREVIEWED THE TOOLPATH AND CREATED A G CODE AND ALL WAS GOOD BUT WHEN I SENT IT TO MACH 3. IT DID NOT CUT THE RECTANGLES CORRECTLY. IT LEFT OFF PART OF THE ENDS AND PUT IN CUTS THAT WERE NOT CORRECT. WHEN YOU LOOK AT THE PREVIEW TOOLPATH EVERYTHING LOOKS GREAT BUT IT DOES NOT PUT THAT TO THE WOOD.
I AM USING A C23 BOARD AND A SMOOTH STEPPER WITH ETHERNET CONNECTION.
I RUN VETRIC ASPIRE AND WINDOWS 7 PRO AND MACH3. AS I SAID, IT HAS RAN FOR A COUPLE MONTHS BEAUTIFULLY BUT NOW IS MESSING UP CONSTANTLY.

ALSO IS THERE A GREAT MOTION CONTROL BOARD THAT EVERYONE USES WHEN USING MACH 3, I WAS TOLD THAT MY C23 BOARD IS LONG OUTDATED AND THERE ARE MUCH BETTER ONES OUT THERE ???????

PLEASE HELP

Pages: 1