Hello Guest it is May 06, 2021, 07:08:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - mossman

Pages: 1
General Mach Discussion / Re: New PlugIn just about done..
« on: September 04, 2006, 12:52:40 AM »

I installed the PlugIn with Shuttle Pro.  It works great!

I couldn't find a drop down button option to cycle the jog increment from .1 to .01 to .001, etc.
Also, is there a way to jog just one increment.

Maybe too much to ask, but is there a way to use the plugin and then program the buttons to do whatever you want (vs. just what is in the drop down menus).


James Mossman

General Mach Discussion / Re: Post Processor Install
« on: July 19, 2006, 11:09:34 PM »
I am was using the post processor for the Lathe XR only.  I just got a mill, but have not tried it yet with OneCNC.

I will link to a couple of forum's where I found the post processor from another user who wrote it ("PoppaBear").

The first is the files section of the Yahoo Mach1Mach2cnc group.


The second link is to CNCzone.com -- it has many forums.  This link is to the  "Machine Controllers Software and Solutions > Mach Software (ArtSoft software) > Screen Layouts, Post Processors & Misc" forum.


Hope that helps.


General Mach Discussion / Re: Touch Screens
« on: April 01, 2006, 02:32:35 PM »
Which screen are you using, any special programming? 



General Mach Discussion / Re: Post Processor Install
« on: March 29, 2006, 01:10:44 AM »
I thought I would reply to myself.  It is really a OneCNC issue.

The file should go in the OneCNC setup directory, along with the standard profiles that are already in that directory.


General Mach Discussion / Post Processor Install
« on: March 26, 2006, 01:11:00 AM »
I have a basic question.

I am trying to install the post processor file for OneCNE lathe for use with Mach3.

I have found the file, but I don't know where to put it.

Help please.


Pages: 1