Hello Guest it is March 28, 2024, 06:52:36 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gavit

Pages: 1
1
General Mach Discussion / Re: gcode conversion
« on: February 10, 2018, 09:30:03 PM »
Thanks found it.
I'll need to go through the manual of this thing.

2
General Mach Discussion / Re: gcode conversion
« on: February 10, 2018, 06:10:45 PM »
I got so excited, I went to go check it.
Thanks for the tip.
Placed the license file and it worked.

Now to figure out how 'read' a gcode file.
I want to know the area it covers, and how deep the Z is.
I have broken a mill :(

3
General Mach Discussion / Re: gcode conversion
« on: February 10, 2018, 04:08:19 PM »
Circles?
It should like the following attached file.

4
General Mach Discussion / Re: gcode conversion
« on: February 10, 2018, 03:56:09 PM »
I could check monday.
Did you try loading it and did you get a complete image?

5
General Mach Discussion / gcode conversion
« on: February 10, 2018, 01:09:03 PM »
Hi all,
I've just gotten my cnc machine to work and have been able to trace the road runner gcode file.
I've tried converting a foto into a gcode file, which you can see at https://ncviewer.com/
However, when loading it in mach3, it doesn't seem to be able to draw everything.
It makes part of the route and then stops.
Anyone know what I am doing wrong?

Pages: 1