1
General Mach Discussion / Re: Rounded corners still problematic after switch to exact stop over 89 degrees
« on: February 03, 2018, 01:11:24 AM »Hi,QuoteIt seemed fine the last program I ran but since then I did reduce my acceleration on my x axis but I also don't feel like that's relevant, otherwise feeds and speeds are the same.
The ability of a CNC machine to follow a trajectory is critically dependent on it axes acceleration. The higher the acceleration the better a machine can follow a path.
You need to have as high an acceleration in your settings as you can consistent with not losing steps and having sufficient reserve to accelerate the mass of the table
and workpiece.
Craig
I understand, but if it was running in exact stop mode like it should be given the setting then the acceleration should be irrelevant in this case