Hello Guest it is March 28, 2024, 05:46:39 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ftgsign

Pages: 1
1
Thanks Tweakie,
I just tried that, but with no avail.  still happening...i think ill toss a dedicated video card in it and go to serial

2
This may not be the place to post this...( please advise)  I have been using mach3 to run my 4x8 CNC router for a few years( LOVE IT) But i just swapped out computers to a HP with windows 10. and copied all my files over. it works as before flawlessly. however when I send a file to run the screen goes blank. CNC runs as normal but the screen comes on and off randomly. if you mouse is hovered over any of the buttons even though you an see them they work? has anyone seen this issue???

Pages: 1