Hello Guest it is March 29, 2024, 09:07:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Tim Rowe

Pages: 1
1
Thanks, Mike. I don't know how I missed it!

2
Mach3 under Vista / Setting the jogging speed in Mach3 - can you help?
« on: January 14, 2018, 11:37:48 AM »
Hi, I'm just setting up my plasma cutter table.

It would be very helpful to be able to change the jogging speed of the torch so I can slow it right down sometimes. (With the torch firing I could cut off the thin waste pieces 'manually' - that is, without having to generate a bit of code.)

I presume this is done all the time but I'm new to Mach and I haven't found a way to set the speed.

Please can you help?

Thanks,

Tim

Pages: 1