Messages

1

General Mach Discussion / Re: Homing Switches

« on: March 21, 2020, 08:54:20 PM »

I am using micro switches and the z axis dose move off the switch ut mach still keeps moving the machine dose not keep moving

2

General Mach Discussion / Homing Switches

« on: March 21, 2020, 07:34:05 PM »

When I ref all home the z axis makes the switch and comes off the switch and stops but in mach3 it stills show the z axis is still moving. so it will not ref home any further than the z axis. Has anybody had this problem and if so what did you do to correct it.

3

General Mach Discussion / Mach 3

« on: March 14, 2019, 03:59:58 AM »

The problem I have is when running a program my cnc will not run faster than 58 ipm, even if I manually increase the feed rate. So is there something in mach 3 that puts a limit on how fast your feed rate is? If so how do I change the limit?

Thank You
Dennis Killian AKA capdenny

4

General Mach Discussion / Re: Probing

« on: March 18, 2018, 03:36:40 PM »

 Try This Link  https://item.taobao.com/item.htm?id=41502492918

5

General Mach Discussion / Re: Probing

« on: March 18, 2018, 03:33:12 PM »

 

This Link Works For Me  https://item.taobao.com/item.htm?id=41502492918

6

General Mach Discussion / Probing

« on: March 17, 2018, 11:23:16 PM »

Hello,

I am a newbie and I am trying to set up a 3 axis probe. I am using a Bit Sensor breakout board. I can not get the probe work. I have tried using all the inputs and all the pins but still nothing. I can not get a picture of the board, but I do have a link that shows the board ( https://gd3.alicdn.com/imgextra/i2/1/TB1gZBOGp*********XX8Xp***************************X_!!1-item_pic.gif_400x400.jpg ).
If you could can you tell me the settings in mach3 and where on the board I connect.

Thank You,
Dennis Killian
star27@charter.net