Hello Guest it is August 14, 2020, 01:44:48 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Andrei Dumitru 1

Pages: 1
1
Yes thank you I tray whit a program with less line and is working, thank for lighting my life :) I will buy the program

2
this is the movie whith problem

https://vimeo.com/248034301

3
Hello
I use this forum because I have no solution to my problem. i was building my cnc and I used a MACH 3 MOTION CARD MKX IV controller, the problem is that when I open a Gcode file in Mach 3 with the plugin for this card it is totally different from what I designed, if I disable the NcUsbPod plugin then mach3 open the file Gcodem I tried to change the format (tap, nc, ncc, gcm etc.,) the same result

4
General Mach Discussion / Re: XHC Mach3 4-axis control card
« on: December 19, 2017, 02:16:18 PM »
problem is if i open the Gcode whitaut ncplugin is working perfect m but when i select the plugin mach 3 dont see in the same way the same Gcode. i have a movie whith this problem but i dont know hau to post
  ALEX HE i send you this movie on skipe

5
General Mach Discussion / Re: XHC Mach3 4-axis control card
« on: December 18, 2017, 01:38:19 AM »
Thanks but now is to late, but whay mach3 is no opening corect the program from fusion-360 you have some ideas?

6
General Mach Discussion / Re: XHC Mach3 4-axis control card
« on: December 17, 2017, 11:14:12 PM »
Hello, I built my own cnc and I use Mach 3 mk IV controller and I use Fusion-360 for projects, problem is when I open a project for cut in Mach 3 is not complete or total rong and if I open the same project in Mach 4 is perfect the same like in fusion 360, my question is I can use this controller for Mach 4?

Pages: 1