Messages

1

General Mach Discussion / Re: Dolphin v10 post processors

« on: September 20, 2018, 05:04:17 PM »

Thank you all for the advice.
I asked Dolphin about the fact that their post processor download site is not working. They are aware of this and are intending to have it running again as soon as possible.
They have also sent me the files that I need, so the learning begins.
I am very impressed with the help I have received from them considering I was asking for help with a very old version.

2

General Mach Discussion / Re: Dolphin v10 post processors

« on: September 19, 2018, 08:32:00 AM »

Thank you for that, I will play and see what works while I wait for Hood to see my post.

3

General Mach Discussion / Dolphin v10 post processors

« on: September 19, 2018, 06:43:40 AM »

Can anyone help with copies of post processors for Dolphin v10 (I think v11 & v12 work)
Dolphin's post processors pages are not working! (Mill links are NOT FOUND) and lathe are DEAD.
I's lathe that I need most, but I should like to have mill also. (For Mach3)
If anyone has tips on using this software with Mach3, That would be great as I am new to lathe work.