Messages

1

General Mach Discussion / Re: Mach3 feed rate issue

« on: November 28, 2017, 03:34:20 AM »

pressing the reset effect for one line only and back to slow speed..

2

General Mach Discussion / Re: Mach3 feed rate issue

« on: November 23, 2017, 02:59:25 AM »

Velocity is 2500.2
Feedrate 1000
Units/Min 34.11
FRO 35.9
FRO%  4
overriden bar is blinking red
no green bar is viable

3

General Mach Discussion / Mach3 feed rate issue

« on: November 22, 2017, 09:53:46 AM »

Hi,
am not able to change the feed rate in Mach3.
using CUT2D and loading the G code to Mach3 the number under feed rate will change according to the CUT2D file but units/min will always range 113-118 no mater what is the feed rate.
another problem is that green bar of the feed rate is not show in the screen.
what can be done to solve this problem ?