Hello Guest it is August 06, 2020, 03:41:20 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - npalen

Pages: 1 2 3 »
1
General Mach Discussion / Re: Starting Mach3 Mill Causes Computer to Reboot
« on: November 27, 2018, 08:03:11 PM »
Worked as advertised!  Thank you very much!

2
General Mach Discussion / Re: Starting Mach3 Mill Causes Computer to Reboot
« on: November 27, 2018, 04:31:31 PM »
Yes, I'm running Windows 7.  How can I unwind the last four updates?
Thanks.

3
General Mach Discussion / Starting Mach3 Mill Causes Computer to Reboot
« on: November 27, 2018, 12:31:53 PM »
Had been working fine but now causes computer to reboot with "safe mode", "normally etc options.
Any idea what is causing this inability to run Mach3 Mill?
Thanks for any help

4
General Mach Discussion / Re: Digitizing Point Cloud Or "Bed of Nails" type
« on: December 10, 2017, 08:48:25 PM »
I did get that corrected but am unable to get the digitizer to post any code to mach3.  Can you try it there on your end to see if it will work for you?
Thanks for your help.

5
General Mach Discussion / Re: Digitizing Point Cloud Or "Bed of Nails" type
« on: December 10, 2017, 12:25:14 PM »
This is what I get when trying to debug the modified file:

6
General Mach Discussion / Re: Digitizing Point Cloud Or "Bed of Nails" type
« on: December 08, 2017, 07:45:23 PM »
Yes, it seems strange that it won't post over to Mach3 after one run.  Must be something in the code that needs a reset?

7
General Mach Discussion / Re: Digitizing Point Cloud Or "Bed of Nails" type
« on: December 08, 2017, 05:01:13 PM »
Would sure like to get it working.

8
General Mach Discussion / Re: Digitizing Point Cloud Or "Bed of Nails" type
« on: December 07, 2017, 10:59:57 PM »
The code you posted fixed the wizard and I was able to run one sequence to prove it.  Then, on a second try, it would not post over to Mach3.

9
General Mach Discussion / Re: Digitizing Point Cloud Or "Bed of Nails" type
« on: December 07, 2017, 10:58:12 PM »
I'm talking about the digitizing wizard. 

10
General Mach Discussion / Re: Digitizing Point Cloud Or "Bed of Nails" type
« on: December 07, 2017, 06:10:37 PM »
I downloaded a new copy of Mach3 to get the digitizing plug-in to work again. 
Would still like to modify the script to allow the retract for only a short distance before the probe moves to the next "hit".  This would make a great difference in the time it takes to digitize a large object such as an archtop guitar plate.

Pages: 1 2 3 »