Hello Guest it is March 28, 2024, 05:34:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Willism

Pages: 1
1
General Mach Discussion / Re: Mach 4 requirements
« on: November 24, 2017, 02:16:52 AM »
Thanks for the prompt reply, i suspected as much. Ill have a look at the link. Thanks again
Matt

2
General Mach Discussion / Mach 4 requirements
« on: November 23, 2017, 11:29:28 PM »
G'day. Im sure you have heard this a million times but im a Newbie to this CDC thing. Im the only one I know who is interested in it so im stumbling around in the dark a fair bit. Ive built a Mill and have it moving about using Mach 3 however I have a very basic understanding of it all. I figured that if im going to learn a new program I may as well learn to use the latest and greatest version, that being Mach4. My question is do I need to buy a new Motion Card given that my board was sold as a Mach 3 compatible board. Its a STB4100 motion card if that helps. I figured at the very least id need a new plugin however i can find no info on the subject. Any help would be greatly appreciated.
Thank
Matt

Pages: 1