1
One on one phone support. / Re: CAN NOT PROGRAM LIMIT/HOME SWITCHES
« on: November 13, 2017, 07:08:20 PM »
When I do an initial program/setup of the software for my cnc machine I don't get any response from the software. I have set it up for both mm and inches and bach again without satisfaction. i then found that after 24 hours the programming took affect. I also don't seem to have control of direction of the y axis, instead of going positive to zero it goes negative and not matter what I set check marks in, it dosen't make a difference. Also, my home switches, which are wired in parallel, don't work unless I press all three at once instead of individually. They almost act as though they are wired in series like my limit switches except that when I press a limit switch all three led's light up as opposed to pressing one home switch and no led until all three home switches are pressed. Limit switches work fine. I got my break out board from 'Build your own CNC' and is for usb hookup. I sincerely am in need of phone support. Thanks. 630-879-9283. Tom Stanfa