Hello Guest it is December 02, 2021, 02:55:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Cheska

Pages: 1
General Mach Discussion / unable to ref all home
« on: March 12, 2019, 03:30:38 PM »
Hey looking for some help here and think its pretty simple fix, i hope!!!
getting a message" requested home axis home switch is active please fix then home" how do i fix?
when in ref all home my dros go to zero my machine stays put. Working on day 2 of frustration.Please help

General Mach Discussion / Re: Where am I?
« on: March 12, 2019, 07:59:33 AM »
That worked thanks

General Mach Discussion / Where am I?
« on: March 11, 2019, 08:17:15 AM »
Through Manual travel all limit switches set fine. home is front left corner fine. when i travel from home into cutting are all dros read negative numbers how do I reverse the polarity of these, making them positive and know where to cut?

General Mach Discussion / Parameters seem off
« on: November 01, 2017, 07:32:50 AM »
Hello everybody I'm trying to create a SOP for our cnc. When Vcarve is loaded to the Mach3 software the artwork appears off the table in the display window. I am hoping  to learn proper way to configure and save settings for the Motors, Home, Softlimits, The DRo to show actual units that match movement and spindle operation from the software not manual
Pleas Help
 Thanks Brian

One on one phone support. / Re: About one on one phone support.
« on: October 31, 2017, 10:09:08 AM »
Hi  I am in desperate need of phone support trying to cut a job and machine is not helping.
Homing limits are way off and limit switches are not being recognized , is it possible for the dro to list distance in inches?
Brian Ouellette

Hello My name is Cheska , New to cad cam we have an Chinese Industrial 8 x 4 cnc with Mach3 Software and Vcarve pro drawing package. I have configured pins and ports and everything moves correctly "3 axis". When I load a Gcode in the Mach 3 the Toolpath window shows that the artwork is off of the table. We set the soft limits but the gantry wants to go  to the artwork in space.  The spindle will not operate through the software we have to operate on/ :-[ off and speed from the control box on the router, Pin configuration? Any help will be greatly appreciated

Pages: 1