Hello Guest it is December 01, 2020, 12:37:53 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - BungalowBill

Pages: 1
Mach3 under Vista / Re: Change Inches to MMs
« on: October 29, 2018, 06:50:41 AM »

I have a legacy Arty, my machine was in inches. I contacted customer support through email and Mosiah was very helpful updated my software and converted it to metric via Team Viewer. I am in Australia so Utah hours are my sleeping hours and I did not have to be at the pc. The feed DRO? could not be changed and remained in inches per foot, I have not been at the machine long enough to work out if the numbers actually relate to ft or mm. I also asked him to change the tool change position to the centre of the bed but the same centre position of the fixed touch off pad ie y = +300    x =  50.? centre of touch off plate, if you know what I mean. I seems easier to change the bits over there and it still touches off ok when setting up the auto tool change.


Pages: 1