Hello Guest it is March 28, 2024, 09:52:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gojida

Pages: 1
1
General Mach Discussion / Re: Mach3 soft limits toggle button
« on: October 20, 2017, 11:23:32 PM »
Yes, it is a new machine.

Homing limits and Ref all button works.

Thanks for the info, I believe I have it working now.

2
General Mach Discussion / Mach3 soft limits toggle button
« on: October 20, 2017, 04:13:29 PM »
In Mach3, the manual speaks of a software limits toggle button.  But it does not tell you where to find it.  When I click on the soft limit button on the program run screen, it does nothing.  The machine coordinate button gets a red border around it when clicked.  I am thinking that I need to click the toggle button to turn the limits on or off.  I can't tell if the soft limits are actually working or not.

My problem is that the limit switches aren't working right.  The movement does not slow down when the table or carriage gets close to it.  If I jog to the switch, when it hits, everything stops and I have to turn the controllers off and manually back it off by hand turning the screw.

I am a noob, and haven't cut anything yet.  Trying to configure.

Pages: 1