Hello Guest it is November 17, 2019, 08:00:39 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - adolfy

Pages: 1
1
General Mach Discussion / Re: text writev4
« on: October 19, 2017, 09:31:18 AM »
ok i see it, 0 90 180 270. but still when i press write nothing happens. I know its just me and thanks for the response.

Jon

2
General Mach Discussion / Re: text writev4
« on: October 19, 2017, 09:28:31 AM »
where would i post a direction, there doesn't seem to be an option. i would have thought that in english words would naturally start on the left.

Jon

3
General Mach Discussion / text writev4
« on: October 19, 2017, 07:16:55 AM »
Hello,

I have just purchased a licence for mach3 and a small 3 axis cnc, mainly for engraving but also so that my son gets some experience programming. When I tried the demo version of mach3 I tried the write wizard and it seemed simply enough, enter all the information press the write button which takes you back to mach3 and a pre written programme albeit with lots of 0's in the demo version. Now I have the full version it doesn't appear to be working. I enter all the information followed by enter each time, press the write key and nothing happens.What am I doing wrong please.

Jon

4
Hello to you all,

I have just joined the club and whilst i have been walking the dogs i realised that it is over 27 years since i last programmed a cnc.

Jon

Pages: 1