Messages

1

PoKeys / Re: Pokey 57CNC Analog Output

« on: October 10, 2017, 10:02:59 PM »

If I put minimmun speed diferent of 00 I get voltage in 1-10 volt output but any S command is ignored, I do not what changed after I close Mach4 and started again, stop working, lock not changeds. now if  after M3  I try S1000  S2000 S 5000 and is ignored or working at minimmun speed if I program any.
Thank you

2

PoKeys / Re: Pokey 57CNC Analog Output

« on: October 08, 2017, 06:20:54 AM »

I have the same problem, I set S3000 speed and other values after M3 not working, if I set minimum speed in mach4 work at the minimum so, I have  0-10 Volt output but not control in S comand after M3
Working fine only one time, after I did the setup, 20000khz  pin 17.....  after I restart the computer one time, stop working.