1
General Mach Discussion / Re: Reference not stopping
« on: September 24, 2017, 12:10:26 PM »
Hi,
i have tested several opportinity. The USB - card leafboy77 works fine an the message that the usb motion is working shows. It seems that all is good. But the reference comes not to end.
I tryed now with the pin10 -13 the old card. also there it is the same result. Reference comes not to the end.
Maybe that I buy another MKX HC card to test.
Thank you for your help. The reference to the pin 10 - 12 was good so I could working with the controller as spare part.
Christoph
i have tested several opportinity. The USB - card leafboy77 works fine an the message that the usb motion is working shows. It seems that all is good. But the reference comes not to end.
I tryed now with the pin10 -13 the old card. also there it is the same result. Reference comes not to the end.
Maybe that I buy another MKX HC card to test.
Thank you for your help. The reference to the pin 10 - 12 was good so I could working with the controller as spare part.
Christoph