Hello Guest it is March 28, 2024, 04:41:52 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - omiadhi

Pages: 1 2 »
1
I have seen codes
mc.AxisSetSpindle
mc.AxisMapMotor
mc.AxisUnmapMotor  in Mach4 API core coding, 
is these codes can work in user defined M code macros?.

2
I am just trying to make mill-turn, having basic 5 axis mill and A axis need to run as Spindle when in lathe mode ,  yes  trying to have index axis and spindle are in STEP/ DIR input

3
Hai is there  anyone have any idea

4
 Hello everyone,

      I am looking for Macro/ Lua script  to TOGGLE  between C axis as Spindle (OBB) accepts S command  AND to index ROTORY axis when ever require  and accept G code commands ,

5
Mach4 General Discussion / Re: How to Swap Axis mach4 Hobby
« on: September 22, 2023, 02:44:37 PM »
Hai anybody can  give answer for this  post , I am also having same requirements in My project , please help

6
Mach4 General Discussion / Re: Axis as a Spindle using Jog? (or Serial??)
« on: December 14, 2022, 02:18:38 AM »
Yes delta B2 having switching between modes using external input ..

7
Mach4 General Discussion / Re: Axis as a Spindle using Jog? (or Serial??)
« on: December 13, 2022, 09:52:24 AM »
Thank you Mr.  mcardoso  your code is very help full.., for serial communication for simple instructions to read and write to microcontroller like arduino , without interrupting mach4

 thank you

8
Post Processors / Re: HSMWorks post processor?
« on: April 24, 2018, 06:38:42 PM »
you may get it in autodesk web its free

9
Mach3 under Vista / Re: Mach3 under win10
« on: September 29, 2017, 12:10:44 AM »
Thank you  for your support  Craig 

10
Mach3 under Vista / Re: Mach3 under win10
« on: September 28, 2017, 02:24:50 AM »
guys could anybody tell where can I buy external motion controller for mach3 need to use in WIN 10  64 bit please

Pages: 1 2 »