Messages

1

Competitions / Re: ******Guess and win a G100 Grex******

« on: May 26, 2007, 08:24:39 PM »

2,680,700
baby needs a new pair of drives

2

General Mach Discussion / Re: rebooting problem

« on: March 31, 2006, 04:20:20 PM »

dell is notorious for bad systems
and you may not be able to uninstall some of there spyware that may interfere with mach
3 worst pc venders are compaq ,dell and gateway
gateway has improved somewhat
I will not buy hp products anymore on that note from what I see of mach software (stilll not at the setup stage)
looks very promising as state of art controller my dual cpu will not work with it so I am at the point of looking at small itx boards to stuff the controllers and system all in one box

3

General Mach Discussion / Re: rebooting problem

« on: March 28, 2006, 02:04:59 AM »

try downloading same version of xp and install that again use your key on side of machine you should be OK
I sell M$ software there wil be conflict with license.
if that does not suite you ask to burrow friends same deal you use your oem license

4

General Mach Discussion / NOOB question

« on: March 24, 2006, 06:56:17 PM »

I did the optimize setup to run mach 3
it says drivers intsalled
did drivertest I get no waveform test says mach 3 is now in control
before I start wiring and config these software is this right
I am running demo version on a dual xeon HT 2.2 ghz I set affinity to the first 2 processors
so the softs would only use 1 cpu

I have been using kellyware with very good results just lookn for better control