Messages

1

General Mach Discussion / parker compumotor microstep drive ax series

« on: January 10, 2019, 09:38:05 PM »

Has anyone ever used parker compumotor microstep drive ax series with a breakout board and mach3? 

2

G-Code, CAD, and CAM discussions / Re: Radius to end of arc differs from radius to startline

« on: September 07, 2017, 06:58:52 AM »

Hi Mike,

Your .dxf is fine.

Your Gcode contains both Incremental and Absolute arcs (or at least variations on the Mach3 requirements for arcs).

My guess is that you need to look for a better / more up-to-date post processor to generate your Gcode with an arc format that Mach3 understands.

Tweakie.

Where do I find new post processors for sheetcam?

3

G-Code, CAD, and CAM discussions / Radius to end of arc differs from radius to startline

« on: September 06, 2017, 08:02:46 PM »

I am getting the following error when I try and run some DXF files "radius to the end of the arc differs from the radius to the start 2508.  I did a search and most suggest ij mode incremental I did this but it than just moves to a different line with the same error.  I am at a loss of how to fix this issue.
I have attach a copy of the G code I am running and the DXF file and the post processor I am running in sheetcam

thanks in advance for the help.

Mike