Hello Guest it is August 14, 2020, 01:20:04 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - agomez

Pages: 1
1
General Mach Discussion / Re: Mach3 port 1 pins current state show all lights off motors wont move
« on: August 10, 2017, 11:01:10 AM »
Hey tweaking,

Thanks I will post the .xml as soon as I get back from work.


2
General Mach Discussion / Mach3 port 1 pins current state show all lights off motors wont move
« on: August 09, 2017, 10:41:24 PM »
Hi, I am new to the forum and to mach3. Just purchased an old Bridgeport boss and redid the entire cabinet, I am using geckos 203v with a db25-1205 BOB I have everything hooked up according to the diagrams, I have checked all cables for continuity and everything is connected properly. I am using a 72V 16amps power supply and I have all superior stepper motors (original BP motors). I have done the initial installation and configuration but I have no light showing on my port 1 pins.

DRO moves but motors dont, they are energized as they lock up as soon as i turn the cabinet on.

I have no estop or limits switches connected to the breakout board since I just want to test for movement first and then add the switches and estop.

I read on another post to check on the voltage from direction pin and ground on the BOB, they all have 1 VDC, should i be getting a different reading when I press the keyboard arrows?

Any help is appreciated

Best Regards

Pages: 1