Hello Guest it is September 29, 2020, 12:25:26 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - rick2017

Pages: 1
General Mach Discussion / Re: RijK words all missing
« on: August 24, 2017, 10:01:07 AM »
Thanks Gerry.
I was pretty sure that was the reason as the G-code generated by another CAM package from the same DXF did not demonstrate the problem.
I just wanted to be sure it was not my setup.


General Mach Discussion / RijK words all missing
« on: August 24, 2017, 06:29:27 AM »
Hi all.

I am a newbie  I did search the site but found nothing relevant. So please bear with me.

I am running mach3 on an XP system. On some G code files, (not all), containing curves I get an error message

RijK words all missing arclinexx.
 xx varies file to file. And Mach3 obviously  does not display the paths or run the file.

Have I something wrongly set in Mach3 setup or is it just a G code creation error of some sort.


FAQs / Re: Windows 10 issue
« on: July 31, 2017, 02:23:20 PM »
Hi all, as a total newcomer to Mach3 I downloaded it for a trial.

I am pulling my hair out trying to get Mach3 to install and run on the latest version of Win 10 (32bit). I have tried compatibility modes for win7 and XP (Also for the install) but the system now boots as though it is running through mud / treacle and when I try to run Mach3 I get a BSOD error - tried to write to readonly memory - and the system crashes repeatedly.

 Did annatara find a solution?

Thanks in advance of any help

(Not a lot of chance of my buying a license at the moment)

Pages: 1