Hello Guest it is March 29, 2024, 08:43:40 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - vphilli

Pages: 1
1
General Mach Discussion / Re: Probing Plug-in
« on: November 18, 2009, 06:31:35 AM »
Was there a resolution on this? I am having the same problem.

2
I'll give that a try. Thanks for the quick response!

3
I have a separate video card.

4
I'm having a problem when I run a long 3D milling operation (over 30 minutes). My PC will lock up and not send signals to my machine. I have to reboot and start cutting all over. I found if I periodically interact with the PC during the cutting operation (such as changing screens or moving the mouse) I don't get a lockup. Can someone point me to the likely problem?


5
LazyCam (Beta) / Re: LCAM 2 offsets
« on: July 25, 2007, 09:02:56 AM »
I just changed the setup load option as you suggested and got a pretty nice outside offset as well as inside one. Thanks.

Do you know how that option works?

6
LazyCam (Beta) / Re: LCAM 2 offsets
« on: July 25, 2007, 08:56:01 AM »
I only see the 07 12 07 release on the download page. Where can I find the 07 25 version?
I'll give the load options a try and see if that helps.

Thanks,
Van

7
LazyCam (Beta) / LCAM 2 offsets
« on: July 24, 2007, 03:15:36 PM »
I just updated to Lcam2 and I'm still trying to understand all the features. I have been trying to use offset and pocketing to cut out an inlay and then a pocket to inlay into.

When I select outside it offsets to the inside. When I select inside, it appears to do nothing. Can anyone tell me what I'm doing wrong?

Attached are my lcam project and my .dxf file if that helps.

Thanks,
Van

Pages: 1