1
General Mach Discussion / "Port 1 Pins current State" no lights...
« on: July 31, 2017, 09:39:04 AM »
On a fresh install of Mach3, when I open the plasma profile and go to the tab “Diagnostics” there are no lights listed under “Port 1 Pins current State” or “Input Signals current State”
But if I open the Mill Profile and go to the tab “Diagnostics” there are 5 lights listed under “Port 1 Pins current State” and the emergency light is flashing under “Input Signals current State”
Why are there no lights under the Plasma profile?
But if I open the Mill Profile and go to the tab “Diagnostics” there are 5 lights listed under “Port 1 Pins current State” and the emergency light is flashing under “Input Signals current State”
Why are there no lights under the Plasma profile?