1
General Mach Discussion / Re: New KX3 not working
« on: June 06, 2017, 03:50:06 PM »
Hi Craig,
I've found the problem I installed the Sieg config files from the disc supplied by them which is for the USB version of the machine, but after searching the Small CNC support forum I found another software version dated 2015. I installed this and after opening the Mach3 Loader there was another profile, KX3 USB, where as the disc only installed the KX3 5000.
Thanks
Steve
I've found the problem I installed the Sieg config files from the disc supplied by them which is for the USB version of the machine, but after searching the Small CNC support forum I found another software version dated 2015. I installed this and after opening the Mach3 Loader there was another profile, KX3 USB, where as the disc only installed the KX3 5000.
Thanks
Steve