Hello Guest it is May 17, 2021, 12:16:53 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - enzed

Pages: 1
1
Thank you. So it can be done. But I'm unsure how it would be done in the post processor (I guess that you're referring to Mach3?). And I'm impressed with your very nice work.
enzed

2
General Mach Discussion / DETERMINATION OF LINEAR LENGTH OF A PLASMA CUT
« on: January 31, 2019, 09:14:44 AM »
Is there any way that the total linear length of plasma cutting can be determined by Mach3 for a specific job? Or is this a question for the Sheetcam guys?

enzed

3
Feature Requests / Re: ARC-ON TIMER AND PIERCE COUNTER IN MACH3
« on: August 07, 2017, 08:06:07 AM »
Thanks for the encouragement, guidance and the offer of assistance and support Tweakie, it is is much appreciated. Yes, perhaps it is not as difficult as I imagine it to be, if I look at the videos and also try and work out something myself. Thanks again and best wishes. Enzed.

4
Feature Requests / Re: ARC-ON TIMER AND PIERCE COUNTER IN MACH3
« on: August 07, 2017, 07:28:04 AM »
Hi Tweakie,

Thanks for the fast response. Developing additional functions for some of us, is easier said than done, especially those of us who, like myself, are beginners with the Mach software, or are not computer and programming wizards! Regards, enzed

5
Feature Requests / ARC-ON TIMER AND PIERCE COUNTER IN MACH3
« on: August 07, 2017, 06:01:59 AM »
On 15 August 2014, DaveK0974 and BLM enquired about the possibility of having 'arc-on timer' and 'pierce counter' functions in Mach3. But I do not see any answers or follow-ups to their queries. Is it possible to have these functions added or activated in Mach3? It would be very useful to obtain information on these parameters whenever plasma cuts are made so as to be better able to calculate cutting and general operating costs. enzed

Pages: 1