1
Mach4 General Discussion / Re: Mach4 ESS Probing Problems
« on: May 16, 2017, 12:17:31 PM »
Thanks thespindoctor.. im reading and trying to understand your code... i hope solve this problem soon..
Felipe
Felipe
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
How did you get this to work in mach3 I tried it an won't work. I found that I need to put in the code how do you do this.
Mine works great. I have used the probing screen with no problems. Now I have written Lua code to probe in a custom program using G31
Put your probe about .1 inches away and issue G31 to probe about .05 beyond at F10. then G90 G91 G0 rapid move back where the axis started. You can open a probe file and it will store the axis values in that file automatically. The file location needs double backslashes. 'C:\\Mach4Hobby\\\GcodeFiles\\"filename.csv"' for example close the probe file when done.
I tried to use a copy of one of the functions from the probe module and it worked but would not work from a do loop.