1
Mach3 under Vista / Slaved axis concern
« on: December 14, 2018, 02:50:54 PM »
Not a pressure matter but any s feedback will be appreciated my only question Is that I have “a” axis slaved to “y”axis they run parallel on each side of my plasma table but I noticed that my “a” stepper doesn’t “stiffen” like “y” does (or any other of my step mottoes for that matter) when I’m motion so there's a bit of wiggle on the movements where axis “a” is, I can actually push on it and it will move , it seems like “y” is doing the entire movements alone all my settings are the same on both axis and I tested the step motors separately they both work . Is this normal or am I missing something here?
Thanks for the help
Thanks for the help