Guest
Show Posts
1
General Mach Discussion / Re: G76 incorrect feed and rapid rates
« on: May 01, 2017, 12:21:48 AM »
Looking for solutions to this exact same problem. Second cut pass and on till the end of cycle, feed and retract speeds are reversed. My pitch was set to .040, and my 1st pass feed was .040 ipr, then the second pass feed was .065 ipr and the retract feed was .040 ipr. and so on till the end of the cycle.
I have read quite a few people with the same issue, but haven't come across any solid solutions yet, except to try earlier versions of the software, which most have tried with no resolve.
Anyway, if anyone reads this, and may know of a cause/cure, please let me know! I'd love to get this friggin thing finally cutting threads after 4 years of owning it!! lol
Thanks!
Brian
I have read quite a few people with the same issue, but haven't come across any solid solutions yet, except to try earlier versions of the software, which most have tried with no resolve.
Anyway, if anyone reads this, and may know of a cause/cure, please let me know! I'd love to get this friggin thing finally cutting threads after 4 years of owning it!! lol
Thanks!
Brian