1
General Mach Discussion / Re: Question before my next Mach3 question.
« on: October 12, 2018, 08:56:16 AM »Hi,Hi Craig, thanks for the reply.QuoteMy Question is about the 3 spindle outputs from the Blue Card, the inverter and Mach3
Well that is the question isn't it......without the manual or manufacturers documentation it could be anything.
Do you have any information on it at all?
Craig
Sadly there is no documents or id on the 'Blue Card' but it is sold on fleebay as TB6560, the PDF sheet is here....
https://www.victortrucco.com/CNC/CorrecoesTB6560/3Axis_Manual.pdf
My question is around the 3 spindle interface lines, marked 'Mout' 'GND' and 'Min', But I think that they only turn 12~36v on or off, so most likely of no use to me at all?
The board and spindle vfd all work as should other than I have no Mach3 control over the spindle, I did search the forum before posting, without result, but unbelievably found a thread on the 1st page in general that I think answers my question?
http://www.machsupport.com/forum/index.php/topic,38480.0.html
tulip6's linky is to the same vfd and issue.
Many thanks, G92