1
Third party software and hardware support forums. / Re: XHC USB Motion Controller Speed Input
« on: November 02, 2019, 11:59:10 AM »
Hi Karol
I never got a reply from the producer, but after a lot of messing about realised that the thing cannot accept a pulse input.
It can only send an output to a variable frequency drive (VFD) and Mach 3 assumes the speed is as set.
I eventually gave up with it and Mach 3 (glad I didn't buy the full version of Mach 3).
I then went on to convert my mill to cnc but using Arduino, GRBL and Fusion 360 all of which works great.
Sorry I can't really help.
Ted
I never got a reply from the producer, but after a lot of messing about realised that the thing cannot accept a pulse input.
It can only send an output to a variable frequency drive (VFD) and Mach 3 assumes the speed is as set.
I eventually gave up with it and Mach 3 (glad I didn't buy the full version of Mach 3).
I then went on to convert my mill to cnc but using Arduino, GRBL and Fusion 360 all of which works great.
Sorry I can't really help.
Ted