1
Mach4 General Discussion / Re: Mach4 Shuts down when loading any g-code file.
« on: November 13, 2018, 09:41:40 AM »
I gave up. Not enough ram on video card. Using new machine instead.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Thanks resalles for the script.Thank you very much!
I got Spindle calibration to work with your script.
Here are the step i took to get it to work.
1. I set the pulley to 1, min to 0, max to 1000.
2. turn on the spindle, set speed from S0 till the spindle start to move. note the speed (mine is about 110 to 120 RPM)
3. Max out the motor speed by type S1000 into the MDI, speed was about 12928
4. change the min spped to 120 and max to 12928 ( I think can set to 12500 or anything max speed toy like)
5. key in the min and max in the spreadsheet
6. Type the speed from from the spreadsheet and key in the measured speed, repeat 100 times.
7. generate the Linearity.dat file.
it works within 200rpm + -