Hello Guest it is April 21, 2021, 02:33:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kutton

Pages: 1 2 »
1
General Mach Discussion / Re: Alternat way to setup tool probe mach3
« on: September 29, 2017, 11:01:47 AM »
Thanks for your time Craig.

2
General Mach Discussion / Re: Alternat way to setup tool probe mach3
« on: September 24, 2017, 01:28:03 PM »
SainSmart 4 Axis Mach3 USB CNC Motion Controller Card Interface Breakout Board

3
General Mach Discussion / Alternat way to setup tool probe mach3
« on: September 24, 2017, 12:16:01 PM »
My board dose not respond to touch prob pins.  Is there another way to bypas problem with board to get tool probe working?

4
General Mach Discussion / Re: New controller
« on: July 09, 2017, 07:58:41 PM »
Thank you.  Would you know what todo when x drive motor only will move to left?

5
General Mach Discussion / New controller
« on: July 09, 2017, 05:02:10 PM »
I changed out my controller.  Controller still lookin for uc 100 driver.  How can I correct this?

6
General Mach Discussion / Re: Mac3 software
« on: March 09, 2017, 07:47:51 AM »
Never get that far

7
General Mach Discussion / Re: Mac3 software
« on: March 08, 2017, 08:23:28 PM »
200 in steps acceleration 10

8
General Mach Discussion / Re: Mac3 software
« on: March 08, 2017, 08:21:50 PM »
All axes.   Currently working on x axes.

9
General Mach Discussion / Mac3 software
« on: March 08, 2017, 08:00:19 PM »
When I go to motor tuning and put velocity  data in.  When I tab to acceleration the velocity goes to zero.

Any suggestions?

10
General Mach Discussion / Re: Need Mach3 help
« on: March 05, 2017, 10:57:08 AM »
Not really any true support.

Pages: 1 2 »