Hello Guest it is March 29, 2024, 12:50:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - edwinchen78

Pages: 1
1
Mach4 General Discussion / Re: DEMO MODE - ISSUE WITH COUNTS PER UNIT
« on: February 20, 2017, 11:09:31 AM »
Thanks for the pointer. Issue solved. Cheers.

2
Mach4 General Discussion / DEMO MODE - ISSUE WITH COUNTS PER UNIT
« on: February 20, 2017, 10:47:24 AM »
Hi There,

I am currently testing my motors with Resolution of 500 Pulse/Rev for both X-Axis and Y-Axis. Y-Axis have a slave motor tied to it. I am using the demo version.

Its direct rack and pinion drive with spur gear travel 100mm in axis per revolution. The Counts per unit keyed in for both axis is 10 for all 3 motors.

My issue is when i try to run G0 X100 in MDI, the X-Axis does not turn full one revolution. It only runs half revolution.

The Y-Axis is spot on.

Please advice. Thanks.

Pages: 1