Hello Guest it is March 28, 2024, 08:18:16 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JimmyLee

Pages: 1
1
Hello all I am James and reside in Michigan.

I am new to CNC Milling and CNC Routers and have been through many struggles and aggravations during the past 6 months with getting my machine purchased, built and running. They say you can never do enough research before beginning this endeavor and that has been proven time and time again to me. What a long nightmare haul it has been. Today I finally got my CNC router moving for the first time and I acted like a kid in a candy store. I am on research overload and still have a long way to go to get this machine producing parts.

I am electronics stupid and have fried 2 gecko g540s by simply not paying attention to what I was doing. Thankfully Gecko repaired the drives for free (what a great company) and I now have motion. I still have some spindle and VFD wiring to figure out but I know that I am now close to conquering it all.

I have read so many post here and still a lot more to read and I have enjoyed and learned something new from just about all of them. I sure wish there was an entire step by step process from start to finish that made since. Youtube has been a great help but everyone has different ways of doing things that I end up getting confused and screw something up.

Anyhow, thanks for listening to my short rant and looking forward to reading more post.

James.

Pages: 1