Messages

1

General Mach Discussion / Re: machine is out by .5mm in x and y axis even after setup

« on: March 02, 2017, 05:34:29 PM »

Tried what you said and i can repeat it accurately for movement to 1000mm but when machining again its out by .3mm. This is strange.

2

General Mach Discussion / Mach3 jogs ok in all direction on all axis but wont move when running programs

« on: January 25, 2017, 02:20:10 AM »

Hi. Any one know why all the motors are jogging in the right direction on all the xis however when you run a programme x and y only run one way. Confusing.

3

General Mach Discussion / Mach3 machine jogging when reset button is on

« on: January 24, 2017, 03:28:13 AM »

Hi, need help please. my machine is jogging/juttering when i press the reset button. this is when the machine should not be doing anything. as soon as i press it again it stops and the system is on. what is going wrong. any help on settings using 5 axis breakout board and nema 23 285oz

thanks