1
General Mach Discussion / Motor on CNC not running but running onscreen in MACH3
« on: January 23, 2017, 03:19:30 PM »
Hello all
Started my CNC the other day after a few years of "rest". I started with a simple sign using the WRITE Wizard and i got a problem i know I had a few years ago. The G-Code looks OK but when I run it the router stops even if it shows on screen that its moving. This happens for a single line but as you can imagine it trows off the whole job. Can you point me to where I should look?
Thanks
Dom
Started my CNC the other day after a few years of "rest". I started with a simple sign using the WRITE Wizard and i got a problem i know I had a few years ago. The G-Code looks OK but when I run it the router stops even if it shows on screen that its moving. This happens for a single line but as you can imagine it trows off the whole job. Can you point me to where I should look?
Thanks
Dom