Messages

1

General Mach Discussion / Re: b/c head post processor

« on: October 12, 2023, 07:47:09 AM »

fusion 360

2

General Mach Discussion / Re: b/c head post processor

« on: October 11, 2023, 11:42:50 AM »

its a motion master that i retrofit with a pokeys57cnc that i run with mach3

3

General Mach Discussion / b/c head post processor

« on: October 10, 2023, 12:48:30 PM »

does any one write post processors? i need one for a zxbc head y table. its for an old motion master. let me know.. thanx

4

General Mach Discussion / Re: NO INPUT SIGNALS

« on: January 15, 2017, 11:55:07 AM »

I think i may have found the problem unintentionally. Apparently db25 cables are not all made the same. SMDH

5

General Mach Discussion / Re: NO INPUT SIGNALS

« on: January 14, 2017, 11:11:10 AM »

I don't know what an xml is.

6

General Mach Discussion / Re: NO INPUT SIGNALS

« on: January 14, 2017, 10:15:13 AM »

I appreciate your reply but it is plainly stated in my description that I have a new bob a new db 25 cable a new computer tower. Its more than something that simple. I don't KNOW the storm did it I just know when I rebuilt my machine I have no inputs. Yes i have 5 volts yes it changes when I hit a switch. I have been THROUGH it. Tried everything. Manual set up auto set up. I am at a loss i have 2 sets of pc's 2 bob's and 2 db25 cables and not ONE INPUT SWITCH

7

General Mach Discussion / NO INPUT SIGNALS

« on: January 13, 2017, 07:21:44 PM »

first of i have changed everything. i have a new breakout board, a new db25 cable, a new tower, a fresh install of mach. pci port is 378, i can communicate with my board ie turn on and off my spindle and move my axis. my inputs worked untill i had a storm.. i have done everything to no avail pleaase help.. thanx in advance