Messages

1

General Mach Discussion / MACH3 retrofit CNC Slotting Machine Broaching

« on: February 03, 2024, 03:26:10 PM »

Hi all, recently acquired a CNC Clotting machine. and stated retrofit, it has a y Axis and a A xais and the head is in of off with inputs to show bottom of stroke and top.
what im trying to work out is how to make some basic code that when input is activated move y axis negative, wen input is activated move y azis positive (same as negative vale and extra)
This will happen to create a single tooth and then rotate a axis and go again.



ive searched and not found anything just yet. can anyone point me in the correct direction?

2

General Mach Discussion / Re: Mach3 CNC table Soft Limits configuration

« on: January 07, 2017, 06:12:08 PM »

Has anybody got a digital dream ddsm5v5.0 to work fully, I'm so close I got the homing to work by adding an extra 2 sequences to the homing button as I found it would except the first 2 sequences then miss 2. The drama I'm having is soft limits it drives through them then pulls a soft limits error. So frustrating I wish I had researched more before buying.