1
General Mach Discussion / Re: Parallel port confirmations
« on: January 29, 2017, 07:17:13 AM »
Hi Joe,
I'm running a Dell Optiplex 755 with Windows XP Pro 32 bit and a CNCDrive HDBB2 break out board;
http://www.cncdrive.com/downloads/HDBB2_manual.pdf
It doesn't actually say whether the board supports 3.3v lpt ports in the manual. Like I say though I am able to activate outputs on the BOB. The only thing I'm unsure is, is the charge pump.
I'm running a Dell Optiplex 755 with Windows XP Pro 32 bit and a CNCDrive HDBB2 break out board;
http://www.cncdrive.com/downloads/HDBB2_manual.pdf
It doesn't actually say whether the board supports 3.3v lpt ports in the manual. Like I say though I am able to activate outputs on the BOB. The only thing I'm unsure is, is the charge pump.